Triac Explanation:
تبليغيرجى شرح بإيجاز لمإذا تشعر أنك ينبغي الإبلاغ عن هذا السؤال.
Triac Explanation:
Triac Explanation:
A triac is similar to a thyristor, but it differs from it in that it conducts current in both directions, not in one direction, and it has three
Terminals MT1 and MT2 are controlled by the third party, Gate.
What is Triac BT136? :-
It is a sensitive gate electronic component used in general purpose bi-directional switching and phase control applications and is designed to connect this sensitive gate directly to microcontrollers, integrated logic circuits and other low power gate driver circuits.
Triac BT136 specifications and features:
Available in 220-T package.
:- The value of RMS on-state current, which is the maximum current that it can handle is 4 amps.
The maximum terminal voltage is 600 volts.
State Voltage value: It is the value of the voltage difference between MT1 and MT2. When the triac is in the ON state, the voltage value changes from a high value to 1.4 volts, and the rest of the voltage goes to the load.
to be run.
Gate trigger current: The value of the gate current is from 2.2 mA to 10 mA.
Holding Current: The holding current value
On the triac, it works, and in this series it is 15 mA, and when it reaches 2.2 mA, the triac turns off.
The value of the Latching current, which is the value of the current that makes the triac in a permanent operating mode, is 4 milliamps.
Advantages and disadvantages of Triac BT136: –
The BT136 Triac has many advantages and some disadvantages, which we will explain in detail.
Features and benefits of Triac BT136:
1: Direct operation from low power drivers and logical integrated circuits.
2 :- High ability to prevent voltage.
3 :- Low latching current for low current loads and lowest EMI when switching.
4:- When the polar voltage – & V Ve is given at the gate terminal it will be activated.
5:- It can operate and control AC waveforms in both half cycles.
6 :- Thyristors use a large size heat sink compared to the anti-parallel design based on two small size heat sinks so TRIAC maintains cost and space within AC power applications.
7 :- In DC applications, silicon controlled rectifiers are mandatory to connect through a parallel diode for reverse voltage protection
أضف إجابة